Vision tools
Two camera tools for your assistant: take a photo, and snap and annotate, which shows you a marked-up picture of the part you asked about.
The Agent Toolbox gives your assistant two camera tools: take a photo and snap and annotate. They are free, included with every account, and the engineer uses them by voice. They work with glasses or with the phone on its own.
Take a photo
Say "take a photo for the report", "grab a snap" or "take a picture" and the assistant captures the current view and saves it. You choose where it goes:
- Onto a form. The photo is added to the form being filled, so it lands in the photo box on the finished document.
- To the job. The photo is attached to the job in your job management system, alongside the rest of the job record.
- As a link to send. The photo is saved and you get a link, so the assistant can email it to the customer in the same breath.
It always saves the photo and gives you a way to use it, so it is never a dead end.
Every photo taken during a session also appears on that session's page in the dashboard, in the Session Photos panel, with its label and capture time.
Snap and annotate
Ask "where is the aerator", "show me the retaining nut" or "how do I do this step" and the assistant takes a photo of what is in front of you, finds the part, and shows you a marked-up picture on your phone. It is built for trainees who do not yet know what a part looks like: nobody has to describe it in words.
Depending on what you asked and what the current step says, the picture can show:
| What you see | When |
|---|---|
| A mark and the part's name | Always. A see-through blue outline around the part, with its name. |
| A close-up | When the part is small or far away, a zoomed inset sits beside the mark. |
| Which way to move it | When the step says to turn, push, pull or lift, an arrow shows the direction. The direction only ever comes from the step or the manual, never a guess. |
| Ghost hands | When the step needs a particular grip or tool, see-through hands show how to hold it. |
| How it looks when done | When you ask what the finished step should look like, a labelled illustration shows it. |
| A part number | Stamped on the picture only when it has been read twice and both reads agree. |
A part marked and named: the timer.
The retaining nut, marked and named.
Which way to turn it, taken from the step: the tap spout, clockwise.
A small part with a close-up inset: the tap aerator.
Ghost hands showing how to hold the spanner on the retaining nut.
If the part is not clearly in view, the assistant says so and asks for a closer look or a different angle, rather than marking the wrong thing. You never have to pick between numbered options.
Every marked-up picture is saved to the session, so it shows in Session Photos on the session's page in the dashboard.
How it works
Both tools capture a still image the moment you ask, so they work hands-free in the middle of a job. The photo tool stores the image securely against your account. Snap and annotate finds the part in the image, checks it, and draws the picture in TrainAR, then shows it on the phone. Nothing needs setting up: both tools are on as soon as the free Agent Toolbox is active.